Skip to Content

Gates - Walk-Through Pressure

People usually choose pressure gates because they think they will not damage their walls as much as the gates which need to be screwed into the wall. In fact, this is not true. Because Pressure Gates are not fixed, they move and always result in scuffing the paint. In most cases chunks of paint will come off when the gate is removed. Some people even create dents in their walls when they turn the pressure pads tight.

These Wall Savers have a non-skid surface which covers a 4 1/4" diametre surface and "saves" you this damage.  The wider surface spreads pressure over ten times the area of the safety gate's original pads. This larger pressure point makes installation much more stable and so reduces the movement.

Wall Savers also help with fit where there are baseboard moldings. When you mount Walk Through Pressure Gates to walls with baseboards the width is smaller at the bottom than at the top of the gate. The pressure pads of the gates fit inside the Wall Saver's recessed "well" ( 1 5/8"W). The well positions the pad 5/8" out from the wall (similar to the depth of most moldings) then equalizing the distance at the top of the gate to the bottom. This is excellent to make the gate work when the difference in measurement between the top and the bottom of the gate finds you would have needed to add a gate extension for the top but not for the bottom.  

NOTE: The Wall Savers are used only with the top two pressure pads of the gate. (The lower pads of the gates are generally put against stronger baseboard moldings and are close to the floor . The Wall Savers are too wide to fit for the bottom pads.)

2/pkg, white in colour

Babysecure provides these Gate Mounting Fixtures as a service to clients who buy our gates. The Wall Savers are sold with orders including a Walk Through gate. There is an additional handling fee if you buy without a gate/ pkg of Wall Savers. For help choosing the most appropriate gate or  Mounting System forward us some pictures and we can give you the suggestions which would best serve your needs.

SR12ws
$8.50
Product

A semi-permanent, clean, trim looking pressure gate gives you the advantages of easy passage between rooms without having to install with screws.

  • Avoid the inconvenience of removeable pressure gates which require you to put the whole thing in, lift out to pass through and then turn around to put it back.
  • The U-shaped frame stays firmly in place with four non-skid mounting pads that protect your walls and woodwork.
  • You walk through the centre by means of an inner doorway which can be opened with one hand and swings in both directions.
  • Not suitable for tops of stairs because the bar bottom of the U is a tripping hazard.
  • Y-shaped fixtures, (see SPINDLE MOUNT, SR29 in ACCESSORIES below)  replace the pads (on one side only) to allow for secure mounting to narrow spindle or turned bannister posts. 
  • Also check out the WALL SAVER which would help protect the wall and create better fit with moldings.
  • Gate also in a Wood look, see below CENTRE GATEWAY - WOOD SR12w.
  • Basic gate measures 29.5H and extends 29" - 37" W.
  • Addition of a combination of 5.5" or 12.5 EXTENTIONS as seen in ACCESSORIES below allows the gate to fit openings up to 6ft W
  • To learn more details about the Extensions needed for your size opening and installation instructions open the ATTACHMENT file below.
  • Choose WHITE or BLACK
SR12
$85.50
Product

Extra tall pressure gate measures 39.4" high making it difficult for children to think of climbing it. Basic gate fits openings 38" - 42.5". Includes two extensions (1 x 3.5" and 1 x 7") allowing gate to fit openings up to 53" wide. Good for busy passageways. At the bottom of the stairs, the height of the gate makes for less need to bend down to reach to open the gate. Simple, one handed operation, with an auto-close, auto-locking door that swings in either direction. Comes with optional wall cups for extra stability.  Not recommended for installation at top of stairs. Great for pet owners with large dogs. Select White or Black metal.

SRw41
$134.00
Product

The Auto Close Center Gateway has all the popular attributes of the Gateway® series:

  • easy pressure fit installation with no tools required;
  • non-toxic, white finished tubular steel; and U-shaped frame with two-way door that automatically closes every time
  •  one-hand operation, closes and locks automatically. 
  • Magnets and a spring loaded hinge close the gate from any open distance.
  • Stays open when the doorway is at right angles to the gate.

The basic Auto Close Center Gateway® is 29 1/2" tall and fits openings 29" to 37" wide. With addition of extensions (See below in Related Items) can fit openings up to 47.5 inches.  

See ATTACHMENT below for installation instructions.

Available in White or Black

 

 

SR12a
$97.50
Product

A semi-permanent, clean, trim design pressure gate that gives you the advantages of easy passage without having to install with screws.

  • It avoids the inconvenience of other pressure gates where you put in and lift out the whole thing to pass through.
  • Different from the U-shaped frame of the Centre Gateway SR12, this gate's door is at one side of the gate.
  • It fixes with the same four non-skid mounting pads that protect your walls and woodwork.
  • You walk through the opening created at the side of the gate by means of an inner doorway which can be opened with one hand.
  • Not recommended for top of stairs because the bottom pressure bar of the gate may be a tripping hazard.
  •  Additional Y-shaped SPINDLE MOUNT, SR29 can replace the pads to allow for secure mounting to narrow spindle bannister posts on hinge side only. Comes in WHITE only.

 Basic gate is  29½" H and fits opening between 30" - 36"W.5.5" EXTENSION KIT (use only one) extends gate to 41 1/2" wide.Refer to Attachment below below for more installion details.

SR35
$72.95
Product
 

Never trip on your gate again, with the KidCo Step Plate. This Step Plate allows you to safely walk through the doorways found in Walk Through or Wide Opening gates. No more worrying about stumbling on the bottom bar across the opening. Instead of the blunt square bar, this step plate creates a ramp. Installs by lifting the gate up and sliding down into the Step Plate.  Get two... one for each side. As with all Walkthrough Gates, not safe to use at direct top of stairs.

Gray in colour with a textured finish for added safety.

 

 

SR29sp
$5.50
Product

Crystal Baby Gates blend contemporary modern design and the higher standard of safety to create an elegant solution of unparalleled safety for your home. Look beyond the beauty of the crystal clear professional grade Acrylic, and you’ll see a world-class child safety gate that meets the toughest European Safety Standards as well as US and Canadian Standards. The AccuInstall Indicators™ make installation easy and most importantly provide peace of mind that your baby gate has been installed correctly and safely – the first time.
The clear silhouette of the Qdos Crystal Baby Gate allows light to filter through every surface and invites the safety gate to become a part of your home design. Beauty and safety, together at last!

Easy Push-Close function with At-A-Glance Indicator™ shows when door is securely locked

Basic gate fits openings 29” – 37” (76 - 94 cm) with two included extensions

With additional extensions up to 48” (111 cm)

See ATTACHMENT below for installation instructions and chart for extensions.

SR49
$249.95
Product

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

The GateMate is a universal floor protector protects wood floors from scratches caused by Walkthrough Pressure or long width gates (Configure or Hearth gates) with inner doorways. Rubberized-like treds on the bottom also helps to give some stability to keep the gate from moving. There is a “glow in the dark” feature to alert sleepy parents of the tripping hazard at night.

Fits all manufacturers’ gate frames
● The two floor protectors can be used together on one gate or separately on two gates
● Glows in the Dark to alert of bottom bar tripping hazard
● Clear color to blend with all colors of gates
● Pack of two

SRGM
$17.95
Product

The Pinnacle Gateway is a hands-free, auto close pressure mount gate.

  • The one-of-a-kind combination of these two features is what makes this high-end gate unique.
  • Foot pedal operation makes it easy to use. Once depressed, it waits in an unlocked position (marked with a green indicator) until the gate door is pushed open. After walking through, a spring loaded hinge and magnets combine to draw the gate closed automatically. 
  • It's slim profile also allows it to be used with a closed room door.
  • Whether opening or closing this gate, your hands are free to carry the baby or objects with you.
  • For more detailed information and installation instructions see ATTACHMENT file below.
  • Fits into openings from 29" to 47.5" wide with the addition of 5.5"extensions. (see 5.5" Extension in ACCESSORIES below)
  • Also check out the WALL SAVER, below which would help protect the wall and create better fit. 
  • Following is guide to selection of appropriate combination of extensions for your opening.

Basic Gate  extends from 31½" - 37"W

For openings 37" - 42½"  purchase one  5.5" Kit

For openings 42½" - 47½"purchase two 5.5" Kits

Available in White
 

SR46
$134.75
Product

Discounted - Was $120.95

A semi-permanent, clean, trim, European design pressure gate that gives you the advantages of easy passage without having to install with screws.

  • It avoids the inconvenience of other pressure gates which require you to push the whole thing in place, lift out to pass through and then turn around and replace it.
  • The U-shaped frame stays firmly in place with four non-skid mounting pads that protect your walls and woodwork.
  • You walk through the centre by means of an inner doorway which can be opened with one hand and swings in both directions.
  • Not suitable for the top of stairs because the bottom bar of the U will be a tripping hazard.

 

Unique additional Y-shaped fixtures (see Spindle Mount, SR29 in Accessories below) replace the pads to allow for secure mounting to narrow spindle or turned bannister posts.

Look below for a BLACK or WHITE look in the same style of gate  SR12. 

Open ATTACHMENT below for more installation instructions and a reference guide to the the number of extensions which will fit your measurements.

Basic gate is 29.5"H and  28" - 36"W. With addition of SR5.5" EXTENSIONs, see below, gate can fit into openings up to 47" wide.

 

SR12w
$89.75
Product